How to Repair Airbag Module

How to repair airbag module

Every vehicle produced keeping in mind the safety of travellers contain various safety equipments. Of which, the airbag is a significant safety device that is situated on the steering wheel or dashboard to slow down rapid motion of a passenger in case of the insurgency of the vehicle. While vehicle crashes, airbag should open instantly to prevent any damage to the inmates. Any delay in deployment in the opening of an airbag can cause great harm during a crash. Thus, this becomes compulsory for every driver to ensure proper repair, maintenance and care of the airbag. This write up answers the popular question ‘How to repair airbag module’.

If there is any malfunction in operation of the airbag, airbag module situated in the dashboard gets illuminated automatically as a warning. This is a clear indication to visit a mechanic and conduct a maintenance check of your vehicle’s air bag system. After the repair, the warning light and airbag system can be reset instantly.

Why to repair airbag module?

There is no need to buy a new module as the crash data of the old one can be easily formatted to make it usable. After that, the only task is to place the module in its original place, turn the warning lights off and use the system as new as before.

How to repair airbag module?

If you are considering bringing back life to your airbag module after airbag inflation, then these simple steps can probably save you hundreds of dollars. If you have not performed that kind of job earlier, this might take 5 minutes to do so. Resetting of the airbag module needs to equipments like socket wrench and socket set.

You need to take out the module and reset it by a professional mechanic. After assembling the reset airbag module, you can opt for these steps for turning the lights off and getting module to work as before:

1.      Open up the hood. Using the socket wrench, loosen the nuts retaining clamp of negative cable wire.

2.      Cautiously slide that cable clamp and take it off the negative terminal of the battery.

3.      Just wait for a couple of seconds and connect the battery terminals as before. Tighten previously opened retaining nut with the help of a socket wrench. After restoration of power, the airbag module gets reset.

4.      Put the key in. Turn on the ignition to “II” position. Verify if the module light is off.

Following the above mentioned procedure, you can turn the lights off and get rid of the warning signals of Supplement Restraint System (SRS).

Though the airbags are considered as safety equipment, they are equally dangerous if the users do not have proper information how to use them. Thus, proper installation of airbags and its module is to be ensured. You will hardly get any problem in implementing these simple steps for “How to repair airbag module” by yourself. If you are still unaware of the technical glitches; contact a concerned professional for performing it for you.